Greater Tulsa Area Classifieds Moderated Newsgroup > Turley
> Cnc slides, drives and power supply
Cnc slides, drives and power supply
Here is a bunch of stuff I bought for a cnc project and never used. There are 6 gecko drives that were used and checked before I bought them. I don't remember what specific type they were. There are also 5 stepper motors, I think about 270 ounce but I'm not sure. See the detail of the label for more info on them. I have not tested the geckos or steppers but think they are fine. There is a large heavy heat sink milled for 3 of the geckos. It is 3-5/16 X 2-1/2 X 9-5/16. The power supply is a Power-One 48vdc @ 10Amp w/ovp and 26Amp surge. The voltage adjusts from about 27 to 51 volts dc. It is a 17 inch rack mount and has some dings and scratches but looks fine. I tested for voltage but not current. There are 5 linear slides. One is a Micro Slide SE050C-100-001. It is 2"wide by 4" long by 1" thick with 3" travel. Two other slides are THK 2K01. They are 13.75 long X 15/16 X 5/16 thick with 10-3/16 travel. Two other slides are IKO LWL 12. They are 28.5 long by 0.473 wide by .0333 thick with 25.75 travel. All the slides runs smooth and show no wear. I don't think they were ever used. There is however a little dirt and surface rust in some of the mounting holes. There are a few blemishes but I don't see any in the areas that are critical.